Motion F-16 Falcon User Manual

Email:[email protected]://www.motionrc.com

page6WhenaLi-Poisdischarged below 3V per cell, it will not hold a charge. The ESC protects the flight battery from over-discharge using Low Voltag

page7Assemble the planeInstall the main wing4. Install the front landing gear. The flat spot of the strut will be used to hold the strut firml

page8Assemble the plane3. Apply the mixed epoxy to the starboard wing and fuselage mating edge using a brush or other applicator.4. Fit the wing

page9Assemble the planeInstall the horizontal stabilizer 1. Install the control horns on the bottom side of the stabilizer as shown. 2. Glue the po

page10Assemble the planeInstall the vertical fin1. Glue the vertical stabilizer into place.2. The wrong way to mount the air speed head.4. The wro

1. Put the Z-bend end of the linkage into the desired servo control horn hole. It is a tight fit and should allow the linkage to move just

page12Assemble the plane1. Attach aileron servo to the Aileron channel of your receiver. Elevator harness goes to elevator channel of your rece

Center of GravityWhen balancing your model, adjust the motor battery as necessary so the model is level or slightly nose down. This the correct balanc

page14Get your model ready to flyImportant ESC information1. The ESC included with the F-16 has a safe start. If the motor battery is connected to

The transmitter and model setuppage15Get your model ready to flyBefore getting started, bind your receiver with your transmitter. Please refer to you

F-16 FalconOPERATING MANUAL

page16Get your model ready to fly2. Make sure all servo arms are fully vertical. If not, adjust the servo arm by using the trim function on your ra

page17Get your model ready to fly1. Caution: Never visually test the rotating direction of the rotor due to it’s vectored thrust. Before testin

Monitor your flight timeFind a suitable flying sitepage18Before the model flyingAs a precaution, an operational ground range test should be performed

page19Flying courseTake offAlways choose a wide-open space for flying your plane. It is ideal for you to fly at a sanctioned flying field. If you are

Extra propeller noiseor extra Vibration.Reduced flight time oraircraft underpowered.Control surface does not move, or is slow to respond to controlinp

AMAIf you are not already a member of the AMA, please join, The AMA is the governing body of model aviation and membership provided liability insuranc

Exceptions: ◆ Free Flight fuses or devices that burn producing smoke and are securely attached to the model aircraft during flight. ◆ Officiall

Read the ENTIRE instruction manual to become familiar with the features of the product WARNING: before operating. Failure to operate th

Table ofcontentsKit contents 1The spare parts list

Kit contentsReplacementpartsfortheROCHobby F16 Falcon are available using the order numbers in the Spare parts list that follows. The fastest, mo

page2The illustration of the spare partsKC-101 KC-102 KC-103 KC-104KC-105KC-109KC-113KC-106KC-110KC-114KC-107KC-111KC-115KC-108KC-112KC-116KC 109 Miss

page3Kit inspectionCaution: All instructions and warnings must be followed exactly. Mishandling of Li-Po batteries can result in fire, personal injury

Electrical ParametersParameterMin Type Max UnitWorkingVoltage91 21 6VInputPower1 5 WWorkTemperature- 204 5℃StoreTemperature- 206 5℃ChargingStop

Using Steps:1. Connect the charger to adapter with enough voltage and wattage, then the Power LED will turn on;2. Connect 2S/3S battery pack to the