Motion 42-02-S028 User's Guide

Motion Control Engineering, Inc.11380 White Rock RoadRancho Cordova, CA 95742voice 916 463 9200fax 916 463 9201www.mceinc.comUser Guide,Universal Seri

MCE Universal Serial Network4 Manual # 42-02-S028 A1ConfigurationAfter connecting power, “INITIALIZING BOARD COMM” will appear on the USN-BASE assem

Configuration5Escalator OnlyIf you are not configuring an escalator, proceed to IP Setup.An escalator connection has additional parameters that need t

MCE Universal Serial Network6 Manual # 42-02-S028 A1Communication ConnectionsConnections are described for IMC, PTC/PHC, and Motion 3000ES.IMC1. Con

Communication Connections7PTC/PHC1. Connect the external Ethernet cable to Ethernet Port A on the USN-BASE assembly.2. The boards in the controller ar

MCE Universal Serial Network8 Manual # 42-02-S028 A1Motion 3000ES1. Connect the CAN bus wires from the three-wire terminal on lower right side of th

MC USN Information9MC USN InformationThis section describes the features of the USN device.Jumper SettingsThese jumper settings apply to the Rev X3-0

MCE Universal Serial Network10 Manual # 42-02-S028 A1LCD and Keypad• Trim pot R27 adjusts LCD screen contrast.• The interface uses eight functional

MC USN Information11Once the USN has connected to the device it will display the following message:This indicates that the USN board has successfully

MCE Universal Serial Network12 Manual # 42-02-S028 A1• Translation Loop Progress: This screen displays the progress of translating events, paramete

Security Password Default for IMC Connections13Security Password Default for IMC ConnectionsIf the USN is connected to an IMC controller with the CRT

Copyright© 2008, Motion Control Engineering. All Rights Reserved.This document may not be reproduced, electronically or mechanically, in whole or in p

MCE Universal Serial Network14 Manual # 42-02-S028 A1

End User License AgreementThis End User License Agreement (“Agreement”) grants you the right to use the software con-tained in this product (the “Soft

Important Precautions and Useful InformationThis preface contains information that will help you understand and safely maintain MCE equipment. We stro

iContentsIn This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1USN Installatio

ii Manual # 42-02-S028, 12/30/08

1In This ManualThis manual describes installing and setting up the MCE Universal Serial Network product. The USN is used to allow equipment without ap

MCE Universal Serial Network2 Manual # 42-02-S028 A1USN InstallationInstallation instructions include:• MCE IMC and PTC/PHC Controls• Motion 3000ES

USN Installation3Mounting the Board Assemblies1. Determine an appropriate location for the USN-BASE assembly. (Preferred location is in the upper left